AZCO Corp

SUR-SIZE™ Sheeter

TS-54

SUR-SIZE™ Sheeter

SKU: TS-54

This compact, economical sheeter is ideal for low speed applications. Installation is a breeze and setup is done in just a few easy steps.  Simply place the roll onto the unwind shaft, thread the material through the roll feeders, and specify the cut length and quantity on the touchscreen. When ready, the SUR-CUT traveling knife assembly automatically cuts the material with exceptional precision, and with the addition of a slitter station you can also cut the material into strips of a desired width.

The Building Blocks of Automation

Build your own unit!

Standard modules can be purchased alone or in combination to build a solution that meets your unique needs.

ConveyerPunch AssemblySlitter StationStackerTraveling KnivesUnwind/Rewind

This compact, economical sheeter is ideal for low speed applications. Installation is a breeze and setup is done in just a few easy steps.  Simply place the roll onto the unwind shaft, thread the material through the roll feeders, and specify the cut length and quantity on the touchscreen. When ready, the SUR-CUT traveling knife assembly automatically cuts the material with exceptional precision, and with the addition of a slitter station you can also cut the material into strips of a desired width.

  • Reduces your material cost when using rolls
  • Sheets are always in the same place including elevation
  • Only one sheet at a time reduces cost and increases reliability
  • Reduces labor cost: one roll can hold up to 2500 sheets
  • Simple to use: 110 V AC, 80psi [5.5 bar] compressed air
  • Can be used with any palletizer
  • 1372mm [54″] cut width
  • Tolerance: +/-3.2mm [0.13″] at 914mm [36″] or less
  • Cycle rate: 15 cycles per min at 50mm [2″], 6 cycles per min at 1000mm [40″]
  • Precision ground urethane drive rollers advance the material
  • The rollers are turned by a motor which provides accuracy and low maintenance
  • Precision ground ball bearings, which require no lubrication
  • Manually preloaded
  • The knife assembly has D-2 tool steel anvil (can be resharpened) and tool steel disk blade (disposable)
  • Linear ball bearing bushings
  • Pneumatically operated knife assembly that requires 80 psi [5.5 bar] regulated air pressure
  • The unit comes with a non-powered unwind
  • The material is loaded onto a removable shaft with manual core tightening
  • Can handle rolls up to 914mm [36″] outside diameter
  • Unit is PLC controlled
  • Touch screen for easy setup and operation of the unit
  • Control panel requires 110 V AC, single phase, 60 cycles
  • Compressed air 80 psi [5.5 bar]

    Get more information on this product

    • Slitter station
    • No-Product sensors
    • Low-Product sensors
    • All-electric model

    Films, foils, paper, nonwovens, corrugated