SUR-CUT Guillotine Knife Assembly

More Views

SUR-CUT Guillotine Knife Assembly | GO-80

Related Models

Custom Guillotine Knife Assemblies

The Building Blocks Of Automation

Build your own unit!
You may be able to apply for any of these additional products below.

  • Description
  • Accessories
  • Options
  • Benefits
  • Specifications

AZCO offers complete, modular guillotine knife assemblies ready to install as stand-alone or in-line units. These units can be mounted in any position for convenient operation. They cut a wide variety of flexible materials such as film, foil, paper, light gauge metals (.25mm/01 in.), non-wovens, foam rubber, ribbon cables, Velcro and many others. The small SUR-CUT knife assemblies are widely used for cutting various strips of flexible materials. The open frame design gives easy access to the material. Mounting holes allow quick installation.

  • Cut and Home sensors
  • Mounting brackets
  • Spring loaded hold-down clamp
  • Steeper blade angle for special needs
  • Blade options:  stainless steel, Titanium nitride coated blade and carbide for longer life
  • Larger/custom units to 1600mm/66" wide
  • Units designed to fit your requirements
  • Custom guarding for your application
  • Proven, off-of-the-shelf design
  • Holes provided for mounting on flat, single-plane surfaces
  • D2 hardened tool steel blades for long life
  • Simple installation and hook-up
  • Clean cutting
  • Low maintenance

Cutting Rate: Up to 200 cuts per minute. Rate is governed by air pressure and flow rate.

Construction: Aluminum anodized frame, tool steel blades, linear bearings.

Power Requirements: 30-90 psi [2 - 6 bar] compressed air (depending on material).

WARNING! UNIT MUST BE PROPERLY GUARDED AT ALL TIMES TO MEET ALL STATE, FEDERAL, AND LOCAL REQUIREMENTS

Get More Information

Captcha

* Required Fields