Test Strip Cutter

More Views

Test Strip Cutter | Test Strip Cutter from Rolls

Downloads

Related Models

Custom Test Strip Cutters

The Building Blocks Of Automation

Build your own unit!
You may be able to apply for any of these additional products below.

  • Description
  • Specifications
  • Materials

This application requires cutting diagnostic strips from rolls into individual pieces.

The material will be loaded onto a cantilevered unwind that will allow for quick and easy loading.

After being un-wound, the web will travel through a dance assembly that will be used to help monitor web tension and increase overall cut consistency.  The roll feed will be mounted on an angle and servo driven. This will provide the web index control and push the material into the knife assembly. There will then be a plasma coated material guides and a registration eye to see the markings on each strip. The material can be indexed based on either dimensions or a registration mark on the material.

The knife assembly will shear the material and be designed to bring the knife as close to the conveyor as possible. This will allow for a cut and place in one single motion. There will be a material guide that is spring loaded to place the strip felt side up onto the conveyor. The blade and clamp will rise before they reach the point of strip placement.

There will also be a registration eye mounted to see each cleat on the conveyor and signal the unit to cycle. The entire assembly will be mounted on a ½” thick anodized aluminum base plate with the control box mounted perpendicularly to the base plate.

  • The unit will have a 110mm cut area
  • Pneumatically operated knife assembly requires 40-60psi
  • PLC control panel operates on 110 Volts 60 cycles
  • Standard unit can handle a roll of material with a maximum OD of 18", a maximum width of 6" on a 3" ID core weighing less than 50 lbs
Material that is 2.5” wide with felt glued on the surface

WARNING! UNIT MUST BE PROPERLY GUARDED AT ALL TIMES TO MEET ALL STATE, FEDERAL, AND LOCAL REQUIREMENTS

Get More Information

Captcha

* Required Fields