📞 973-439-1428

Cut-to-Length FG-250SP

More Views

Cut-to-Length FG-250SP | Custom Cut-to-Length #212069

Downloads

    The Building Blocks Of Automation

    Build your own unit!
    You may be able to apply for any of these additional products below.

    • Description
    • Materials

    Material:  3/8” x 3" wide pad, with sealed air between each pad. 

    Requirements

    Accurately feed the pads and cut an 8” piece to a registered position in between the sealed areas.  The pads needed to come out in a position to be handed to a secondary process.  Cycle requirements were 80 cuts per minute.

    Our Solution

    We modified our standard FG-250 and added dual tractor drives to handle the three-dimensional padded product.

    • We had eye registration to position the material in the right location to the knife.
    • The unit was servo driven for high force and accuracy.
    • A Smartknife option was included on the knife assembly for higher cycle rates.
    • Infeed rollers with side guides guided the material into the tractor drive assembly.
    • The tractor drive was dual driven with a gear drive system.
    • There was a loop sensor to turn the unit on and off, so that the unit was always assured of material in the process.
    • Unit required compressed air and 110 V power.

    3/8” x 3" wide pad, with sealed air between each pad. 

    WARNING! UNIT MUST BE PROPERLY GUARDED AT ALL TIMES TO MEET ALL STATE, FEDERAL, AND LOCAL REQUIREMENTS

    Get More Information

    Captcha

    * Required Fields