📞 973-439-1428

Slitters

6 Item(s)

per page
  1. Pneumatic Shear-Cut Slitting Station

    Pneumatic Shear-Cut Slitting Station

    Model: Custom Slitting Station SLS-26SP

    Requirements

      

  2. Crush-Cut Slitting Station

    Crush-Cut Slitting Station

    Model: Custom Crush-Cut Slitting Station

    Our customer needed a custom slitting unit five (5) independently-controlled knives, all operated via separate switches. This unit included an output shaft and is motorized lower anvil. Unit will include switches to make each blade independent from the other.

      

  3. Slitter Shear Cut SLS-630

    Slitter Shear Cut SLS-630

    Model: Custom Slitter Station 213001

    Material:  Epoxy and glass composite material, 15” wide and .015” thick

     

    Requirements

    A module shear cut slitter station was needed to take material and slit it down to the proper size.

      

  4. Shear Cut Traveling Knife Assembly

    Shear Cut Traveling Knife Assembly

    Model: Custom Traveling Knife 213067

    AZCO Corporation has designed a shear cut traveling knife assembly ideal for material 1600mm wide and 3mm-55mm thick. This cut to length unit is built to feed the material all the way through the knife assembly. A precision ground urethane drive top roller supplies a force which provides positive traction between the material and the drive system. The brushless servo motor provides high accuracy and low maintenance. A 1600mm [55”] traveling knife assembly shear cuts the material to size. The knife assembly is servo driven with linear guides for extra strength and support. Easy to use, the unit can be bolted right into an existing process. A color touch screen is used to set up the unit. PLC controls run the servo motor drive and the entire process. To interface the unit to the process, a loop sensor is used. When material is present, the unit will operate; if there is no material, it will wait.

    Requires 110V AC single phase power, 15 amp current, and 80psi compressed air.

      

  5. SLITTER CRUSH CUT SLC-630

    SLITTER CRUSH CUT SLC-630

    Model: CUSTOM SLITTER STATION 215072

    This application

      

  6. UNWIND / SLITTER STATION / ROLL FEEDER / KNIFE ASSEMBLY / REWIND

    UNWIND / SLITTER STATION / ROLL FEEDER / KNIFE ASSEMBLY / REWIND

    Model: CUSTOM UNWIND / SLITTER STATION / KNIFE ASSEMBLY / REWIND 215040

    Material

    Varying widths 3/8” – 12 ¾ “ tape

    Requirements

    Unwind, slit, cut to length, and rewind material from roll

      

6 Item(s)

per page