📞 973-439-1428

Roll Feeders

5 Item(s)

per page
  1. AZCO SUR-FEED™ Roll Feed and Unwind Module on stand

    AZCO SUR-FEED™ Roll Feed and Unwind Module on stand

    Model: Custom Roll Feed and Unwind Module on Stand

    Requirements

    This application included unwinding and feeding a 4.5 mil x 1 ½” wide plastic roll of tape. The material operated at speeds of 1700 inches per minute.

      

  2. Lamination Station with Unwind, Rewind, and Roll Feed Assembly

    Lamination Station with Unwind, Rewind, and Roll Feed Assembly

    Model: Custom Lamination Station with UD Dancer and Roll Feed Assembly

    Requirements

    This application required a system with an unwind roll having the following dimensions of 3” core, 18” or less OD, up to 8” wide weighing under 50 lbs.

      

  3. Shear Cut Traveling Knife Assembly

    Shear Cut Traveling Knife Assembly

    Model: Custom Traveling Knife 213067

    AZCO Corporation has designed a shear cut traveling knife assembly ideal for material 1600mm wide and 3mm-55mm thick. This cut to length unit is built to feed the material all the way through the knife assembly. A precision ground urethane drive top roller supplies a force which provides positive traction between the material and the drive system. The brushless servo motor provides high accuracy and low maintenance. A 1600mm [55”] traveling knife assembly shear cuts the material to size. The knife assembly is servo driven with linear guides for extra strength and support. Easy to use, the unit can be bolted right into an existing process. A color touch screen is used to set up the unit. PLC controls run the servo motor drive and the entire process. To interface the unit to the process, a loop sensor is used. When material is present, the unit will operate; if there is no material, it will wait.

    Requires 110V AC single phase power, 15 amp current, and 80psi compressed air.

      

  4. 214045 Unwind + Roll Feeder + Punch

    Unwind / Roll Feeder / Punch / Cut To Length

    Model: Custom Solution 214045

    AZCO SUR-CUT™ Station with a cordless unwind, Brake RF110, punch station, dual tape station and FG-110 cut to length.

    *additional options can be purchased before shipment.

      

  5. Sheeter With Heavy Duty Unwind And Automated Stacking System

    Sheeter With Heavy Duty Unwind And Automated Stacking System

    Model: Custom Sheeter 213081

    This application required unwinding a roll of aluminum, cutting it into 50” long sheets, and stacking them into 12” high stacks. The cycle rate for this application was 9 sheets per minute based on a 56” cut length.

      

5 Item(s)

per page